If you ever get the message “Entering programming mode.. FAILED!” while trying to program your AVR device don’t start messing with your MKII or upgrade its firmware 10 times or messing with the windows drivers like I did, cause that’s probably not the cause and you risk damaging you’re perfectly working MKII. As it turns out its just a faulty connection between the programmer and the target board. This is not likely to happen if you only use the programmer occasionally but I used it for like 50+ times a day and that meant inserting and removing the little 6pin connector a bunch of times. I removed the old 6pin connector, crimped a new one and its working again, so long live the MKII because it is a great tool.
You might be wondering why would I need to use that many times, well its because I’m working on this new project, a quadrocopter based on an atmega64. The microcontroller was chosen because I had a bunch around and ATMEL was kind enough to send me a ATAVRSBIN1 for my project.
The Inertial One System Board delivers a full 9 degree of freedom sensor platform comprising a 3 Axis Magnetometer from AKM (AK8975); 3 Axis Accelerometer from Bosch (BMA150) and a 3 Axis Gyroscope from InvenSense (ITG-3200) connected through an I2C interface.
At $54 its probably the most accessible 9DOF breakout out there and it comes with great sensors. Unfortunately I only managed to test and fly with the ITG-3200 gyro before I had a crash(you crash allot when developing from scratch a new firmware for a quad). Because of the crash a short-circuit happened somewhere on my board and it messed up the ATAVRSBIN1 sensors.
The ITG-3200 is a very good gyro with low noise so to replace the damaged ATAVRSBIN1 and to continue flying I got a wii motion plus which has the ITG3205 inside(its supposed to be just an OEM version of ITG3200). I haven’t done allot of testing with this new ITG3205 but I did notice some problems on the I2C bus, like sometimes the sensor does not respond , which is strange.(maybe the 400KHz freq is too high for the ITG3205 ?).
Anyway enough for now, I’ll post some updates on the project soon.