YourITronics » hack http://www.youritronics.com DIY, Electronics, IT, Gadgets Thu, 29 Jul 2010 09:00:00 +0000 en hourly 1 http://wordpress.org/?v=3.0 DIY Slave Camera Flash http://www.youritronics.com/diy-slave-camera-flash/ http://www.youritronics.com/diy-slave-camera-flash/#comments Thu, 13 Mar 2008 10:24:22 +0000 Florin http://www.YourITronics.com/2008/03/13/diy-slave-camera-flash/ Slave Camera Flash Hack in the picture

Matt Mets wanted to add a slave flash for his camera so he started working on this project by dismounting a flash from an old camera he had around. After doing some research on other projects with the same subject he was forced to build a clock to control the inverter because the original one was stuck into the old camera and was to messy to be extracted. The idea almost worked, but unfortunately the transistors overheated and melt a part of he’s board. He is now working on perfecting the circuit.

Slave Camera Flash Hack: [Link]

]]> http://www.youritronics.com/diy-slave-camera-flash/feed/ 0 Change the message on HP printers http://www.youritronics.com/change-the-message-on-hp-printers/ http://www.youritronics.com/change-the-message-on-hp-printers/#comments Mon, 19 Nov 2007 13:15:46 +0000 Florin http://www.YourITronics.com/2007/11/19/change-the-message-on-hp-printers/ Is you hp printer getting old and boring ? Here is a great tutorial on how to make your hp printer cool again. At the end of this tutorial you get the same old HP printer (that you should trow away and buy a new one like every normal people) but with a new personalized message. Cool

Change the message on HP printers

Link to tutorial

]]> http://www.youritronics.com/change-the-message-on-hp-printers/feed/ 0 How to set the mac address from /etc/network/interfaces in Debian http://www.youritronics.com/how-to-set-the-mac-address-from-etcnetworkinterfaces-in-debian/ http://www.youritronics.com/how-to-set-the-mac-address-from-etcnetworkinterfaces-in-debian/#comments Sat, 27 Oct 2007 07:00:40 +0000 Florin http://www.YourITronics.com/2007/10/27/how-to-set-the-mac-address-from-etcnetworkinterfaces-in-debian/ Install SNMP (Simple Network Management Protocol) on Debian     This is an update to a previous post regarding the change of mac address in Debian. In the previous tutorial I told you can change it by ifconfig from a root account. Now I’m going to teach you how to set an interface mac address using /etc/network/interfaces . This is a better way to set your mac address because the mac you set in /etc/network/interfaces will always load when the interfaces are loaded so you don’t have to worry about the mac after reboot for example. Let’s start by looking at my /etc/network/interfaces it looks like this:

 

#This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).

# The loopback network interface
auto lo
iface lo inet loopback

# The primary network interface
auto eth0
iface eth0 inet static
address 1.1.1.2
netmask 255.255.255.0
network 1.1.1.255
broadcast 1.1.1.255
gateway 1.1.1.1
dns-nameservers 1.1.1.1
dns-search .com
hwaddress ether 00:01:04:1b:2C:1F

Open this file in your favorite editor. I use nano. You can see that my ip address is 1.1.1.2 and my gateway is 1.1.1.1 instead of these in your file you will see your network settings. Now, under the last line of the interfaces file you have to add the following

hwaddress ether 00:01:04:1b:2C:1F

replacing 00:01:04:1b:2C:1F with the mac you want to assign to the interface where you are adding the line. Now save the file with ctrl+x then y to confirm and restart the network service with
/etc/init.d/networking restart
Now type ifconfig and there it is you should see the mac you entered earlier assigned to eth0 (if you choused eth0). You’re done the mac will now load every time the network load’s.

]]> http://www.youritronics.com/how-to-set-the-mac-address-from-etcnetworkinterfaces-in-debian/feed/ 3 How to change the MAC address in Linux (Debian) http://www.youritronics.com/how-to-change-the-mac-address-in-linux-debian/ http://www.youritronics.com/how-to-change-the-mac-address-in-linux-debian/#comments Sat, 22 Sep 2007 18:27:38 +0000 Florin http://www.YourITronics.com/2007/09/22/how-to-change-the-mac-address-in-linux-debian/     Although the physical MAC address is permanent by design and is assigned to your network card by factory several mechanisms allow the modification, or spoofing of the MAC address that is reported by the operating system. This can be useful if you want to keep your privacy or to ensure interoperability. Some internet service providers bind their service to a specific MAC address; if you change your network card or intend to install a router the service won’t work anymore. Changing the MAC address of the new interface will solve the problem.

    Under Linux the MAC address of a network card can be changed by doing the following under a root account.

/etc/init.d/networking stop

ifconfig eth0 hw ether 02:01:02:03:04:08

/etc/init.d/networking start

” 02:01:02:03:04:08” being the new assigned mac.

    Under Fedora Core 5, and possibly in other Linux distributions, to disable and restart networking, you must stop and start /etc/init.d/network, instead of /etc/init.d/networking. Using the described method your MAC address will revert to original MAC address (hardware MAC) after reboot. So if you want to make the change permanently in Debian you have to add

hwaddress ether 02:01:02:03:04:08

into the appropriate section of /etc/network/interfaces so that the MAC address is set when the network device is started.

You can also use the tool MACChanger to change the MAC address under Linux.

]]> http://www.youritronics.com/how-to-change-the-mac-address-in-linux-debian/feed/ 1