TDA2005 2×20 Watt Stereo Amplifier

TDA2005 220 Watt Stereo Amplifier description:
This circuit is a small stereo amplifier for all suitable applications like amplifying small speakers, boxing, etc. It is also suitable for car use but before, the power supply must be choked with at least 150mH and it must give up to approximately 6 to 7 amps during the upstream performance.

Appropriate heatsink for the amplifier is SK08 with a height of 50 mm  (approx. 2.5 K per watt). You should drill the cooler after soldering the board to center it properly. The TDA2005 also needs not be isolated from the heat sink, since the metal mounting part of the IC is grounded. You should use thermal paste to improve the heat dissipation. After the assembly , case construction is left to the builder. 100K potentiometers are used for adjusting the input volume. The potentiometers are absent in the layout. The 100K resistors need only be installed if the 100 K potentiometers are not used as shown in the layout. For full info on TDA2005 220 Watt Stereo Amplifier visit project page.

TDA2005 220 Watt Stereo Amplifier: [Via][schematic, PCB and layout files]